Trucker Numbers

Fuel surcharge calculator

By Daniel Reyes, Finance writer and calculator developer — Trucker Numbers

Enter your diesel price, carrier base price, and loaded miles to see your FSC per mile, total fuel surcharge, and how much of the fuel cost gap the surcharge actually covers.

EIA national average diesel: $3.641/gal(week of 2026-10-13). Pre-filled below. Edit to use your regional or contract price.

Diesel price
Carrier FSC table
This load

Your results

FSC per loaded mile
$0.320
Total fuel surcharge
$160
Steps triggered above base
32
Actual fuel cost (this load)
$280
Base fuel cost (at base price)
$154
FSC recovery ratio
1.27×
Break-even diesel price
$2.05/gal

Estimate only, not financial, tax or legal advice. Check your own figures and contracts before relying on it.

How the calculation works

  1. Steps above base = floor((diesel price − base price) / price increment). Partial steps are dropped; surcharges move in whole increments.
  2. FSC per mile = steps × surcharge per step.
  3. Total FSC = FSC per mile × loaded miles.
  4. Fuel cost gap = (diesel − base) × loaded miles ÷ MPG. This is how much more you spend on fuel compared with the base price scenario.
  5. Recovery ratio = total FSC ÷ fuel cost gap. A ratio above 1.0× means the FSC over-compensates for fuel cost; below 1.0× means you absorb part of the cost increase.
  6. Break-even price = the diesel price at which total FSC equals the fuel cost gap for your truck's MPG. Above this price the step table over-recovers; below it you under-recover.

Worked example

Diesel is at $3.641/gal. Your base price is $2.00, price increment $0.05, surcharge $0.01/mile. On a 500-mile load at 6.5 MPG:

In this example the FSC covers the full cost increase and then some, because the step table was calibrated at 6.5 MPG. A carrier running 5.5 MPG would have a higher fuel gap and under-recover at the same table.

Standard FSC reference table

Base price $2.00/gal, increment $0.05, surcharge $0.01/mile per step. Enter your own values above to recompute.

Diesel ($/gal)StepsFSC ($/mile)
$2.000$0.000
$2.102$0.020
$2.204$0.040
$2.306$0.060
$2.408$0.080
$2.5010$0.100
$2.6012$0.120
$2.7014$0.140
$2.8016$0.160
$2.9018$0.180
$3.0020$0.200
$3.1022$0.220
$3.2024$0.240
$3.3026$0.260
$3.4028$0.280
$3.5030$0.300
$3.6032$0.320
$3.7034$0.340
$3.8036$0.360
$3.9038$0.380
$4.0040$0.400
$4.1042$0.420
$4.2044$0.440
$4.3046$0.460
$4.4048$0.480
$4.5050$0.500
$4.6052$0.520
$4.7054$0.540
$4.8056$0.560
$4.9058$0.580
$5.0060$0.600

Highlighted row is closest to the current EIA price (week of 2026-10-13).

How your MPG changes the recovery ratio

A step table is calibrated for a specific fuel economy, and your truck's MPG determines whether the surcharge actually covers your fuel cost gap. The math is straightforward: the surcharge pays a fixed amount per mile, but the fuel cost gap per mile is (diesel − base) ÷ MPG. On the standard $0.05/$0.01 table with a $2.00 base, a $1.641/gal price increase pays $0.32 per mile — but that recovers 27% more than needed at 6.5 MPG and only about 7% more at 5.5 MPG. Run the same table on a 4.5 MPG heavy-haul truck and the FSC under-recovers badly, because the step table was never built for that fuel economy. The table below shows the same diesel price and table applied to different trucks.

Truck MPGFuel gap per mileFSC per mileRecovery ratio
4.5 (heavy haul)$0.365$0.3200.88× (under-recovers)
5.0$0.328$0.3200.98× (about even)
5.5$0.298$0.3201.07×
6.0$0.274$0.3201.17×
6.5 (typical dry van)$0.252$0.3201.27×
7.0$0.234$0.3201.37×

The practical takeaway: if your truck burns noticeably more fuel than the truck the table was written around, negotiate a richer table (smaller increment or larger per-step payment) rather than eating the shortfall, and verify the recovery ratio on every rate confirmation using this calculator.

Common FSC table structures compared

There is no single industry-standard fuel surcharge table — you will encounter at least three families of tables in rate confirmations, and they can differ by more than $0.15 per mile at the same diesel price. Older ATRI-style tables use a low base price with larger increments, which under-recover when diesel is far above base. Modern contracts written after 2020 usually carry $2.00–$2.50 bases with $0.05/$0.01 steps. Per-gallon surcharge tables (more common in private fleets) add a per-gallon fee rather than a per-mile one, which shifts more risk onto the shipper. Know which structure your contracts use before comparing two offers — the base linehaul rates are not comparable without matching surcharge structures.

Table styleTypical baseIncrement / paymentFSC at $4.00 diesel
ATRI legacy$1.20/gal$0.06/gal → $0.01/mi$0.46/mi
Standard modern contract$2.00/gal$0.05/gal → $0.01/mi$0.40/mi
High-base contract (2022+)$2.50/gal$0.05/gal → $0.012/mi$0.36/mi
Per-gallon surcharge$1.20/galPass-through of pump − base$2.80/gal (~$0.43/mi at 6.5 MPG)

FSC figures computed with each table's own structure. Per-gallon pass-through converts to per-mile using 6.5 MPG for comparison. The calculator above handles any of the first three structures — just enter the increment and per-step payment from your rate confirmation.

Frequently asked questions

What is a fuel surcharge and how is it calculated?

A fuel surcharge (FSC) is a per-mile fee added to the base linehaul rate to compensate carriers for diesel price changes above a set baseline. The most common method uses a step table: for every $0.05 per gallon that diesel rises above the base price, the carrier adds $0.01 per loaded mile. If diesel is $1.65 above the base price, that is 33 steps, so FSC = $0.33 per mile.

What is the EIA base diesel price?

The EIA (U.S. Energy Information Administration) publishes the national average retail on-highway diesel price every Monday. The FSC base price in your contract is different — it is the diesel price the carrier built into the base linehaul rate. Common base prices range from $1.20 (older ATRI-style tables) to $2.50 (contracts written during high-fuel periods).

Does the fuel surcharge cover 100% of my fuel cost increase?

Usually not. A $0.01/mile surcharge per $0.05/gal increment at 6.5 MPG recovers about $0.13 per dollar of fuel increase — far less than 100%. The recovery ratio shown by the calculator tells you exactly how much of your fuel cost gap the FSC covers at your truck's MPG. Carriers with better fuel efficiency recover more; carriers with worse MPG recover less.

How do I find or set my base price?

Your base price is negotiated with the broker or shipper and written into the rate confirmation or contract. If you are quoting a new shipper, many carriers use the ATRI-recommended table starting at $1.20 or the ATA's table. Setting the base higher protects you if diesel falls (smaller surcharge) but may lose you loads to carriers with lower bases when fuel is cheap.

Can I enter my own diesel price instead of the EIA figure?

Yes — the Diesel price field is editable. The EIA national average is a common contract reference price, but some contracts reference a regional average or the rack price in a specific city. Enter whatever price your rate confirmation uses.

More trucking calculators